This patch adds the documentation for building and running RTEMS on the Kendryte K210
RISC-V SoC. The generic riscv introducion was re-arranged to list the multilib variants
then the specific hardware targets. In addition a couple of errors were fixed for the
generic QEMU commands.
V2 corrected a typo, expanded K210 Console UART parameters, and addded a hyperlink
to renode.io install instructions.
Closes#4876
The BSP is capable of initialising the hardware being the first software
that takes control on hardware reset (after the bootrom). For instance,
using on QEMU's virt platforms, RTEMS runs as a bios without BBL.
Similarily, RTEMS can also be run on harware/FPGA and loaded using
GDB; the bootrom (or a GDB script) should just set the a0/a1 registers
with the boot HART ID and DTB address respectively.
This patch adds details on the packages needed for the RTEMS
source builder on openSUSE Leap 15.4 64 bit. The commands
were tested on a new install with the RTEMS source builder
master branch.
Update the riscv documentation for the Microchip PolarFire SoC
BSP variant including information about SMP test procedure
for the Microchip PolarFire Icicle Kit.
This patch adds the relevant documentations required for booting the new BSP.
JTAG support is added for debugging. I have built the HTML docs and verified
them.
This patch adds kind of HOWTO to the stm32h7 BSP description. The howto
discusses various tools from STM tool-chain and how to use them in order
to configure board for RTEMS and to upload RTEMS application binary
to the board. The patch also adds more supported boards to the table.
Sponsored-By: Precidata
This patch is for the rtems-docs repo. I added details on the procedure I
used to boot RTEMS images on the Xilinx ZCU102 board. I applied this patch,
and generated the HTML docs, and everything looks ok to me.
The device tree has to be aligned correctly. rtems-bin2c has a new
parameter for that. This patch uses this parameter to generate the right
alignment and makes it more clear how to use the generated C file.
Updated the latest version referenced of Ubuntu to 20.04, updated
package list, and identified what packages need to still be installed
afterwards to pass sb-check.
Closes#4110
