The i.MX6UL (and some others from the i.MX family) have shared MDIO
lines for multiple FFECs. This patch allows to use the MDIO interface
from another Ethernet controller.
Note that you have to make sure that the FFECs are initialized in the
right order. Normally that can be done via FDT.
The TI driver has been moved to RTEMS so the driver can be removed
from libBSD.
The following files have been removed from libBSD and moved to
RTEMS.
1) ti/am335x/am335x_scm_padconf.c
2) ti/am335x/am335x_scm_padconf.h
3) ti/ti_pinmux.c
4) ti/ti_pinmux.h
Update #3784
With the previous fix, it could happen that the end of the packet hasn't
been flushed. For example assume the following addresses:
ds_addr: 0x81c804A
ds_len: 0x57
In that case the data ends at 0x81c80a1. But due to the rounding the
area from 0x81c8040 to 0x81c80a0 would have been flushed.
This fix now first calculates the start and end address, aligns these
addresses and then recalculates the len that has to be flushed.
Update #4180
Update the host frame interval after a device connection. Select also
the FS/LS PHY clock. It is not clear if this works on all platforms.
Update #3910.
- The files in the i386 directory have been moved to common x86 directories by FreeBSD:
- freebsd/sys/i386/include/machine/bus.h
- freebsd/sys/x86/include/machine/legacyvar.h
- freebsd/sys/x86/include/machine/specialreg.h
- Add header files in rtemsbsd directory to direct compiler to new files
- cpusets and SMP are currently not supported in libbsd for RTEMS
- Disable the ifc_cpus context variable and replace its usage,
essentially hard-coding for cpu 0
- callout_reset_on takes a cpu which is ignored by the subsequent call
to callout_reset_sbt_on in RTEMS.
- The macro is redefined to discard the cpu argument directly which
enables uses of it with cpu-dependent variables (disabled in
RETMS) without further changes, e.g. in iflib.c.
Some targets support only flushing or invalidating complete cache lines.
In this cases misaligned buffers might lead to unexpected results. This
patch adds a flag that allows drivers to signal to the bus dma driver
that it is OK to round a buffer to the next full cache line. That's for
example necessary if a driver wants to send out 14 byte via a USB DMA.
Only the driver knows whether these 14 bytes are located in an otherwise
unused cache line aligned buffer.
There is a bug in the #ifdef regarding FDT so this file hasn't been
compiled. If that bug is solved, the driver doesn't work for some other
reason.
With the FDT-bug the driver hasn't been used by anyone. So just remove
it again.
This is not a nice solution but it should work on all chips. As soon as
FreeBSD has a nice solution via the USB PHY driver, this should be
replaced.
Update #3869.
